Two starting points

Drylet sells a line of dry, powder-form products built around what it calls a patented microbe-delivery platform, as its website describes it as of September 2026: specially selected, non-GMO, non-pathogenic (Biosafety Level Class 1) bacterial cultures embedded, or “seeded,” inside engineered, porous, inorganic particles, a silica-type carrier material Drylet markets as Micro Bioreactor particles and calls biocatalysts. The particles are described as protecting the microbes in transit and giving them surface area to reproduce once the dry product reaches the sludge layer. The catalog is organized by application: Liquify GT for grease trap and kitchen drain bioremediation, ManureMagic for livestock manure pits and lagoons, BioDredger for long-term sludge reduction in wastewater lagoons, BioReact to enhance hydrolysis in anaerobic digesters, and Aqua Assist for municipal wastewater treatment, plus Sonar Mapping Services, a sludge measurement and diagnostic offering separate from its bacteria products.

We start from a different point of intervention. DRP Accelerator is an inorganic compound that carries usable oxygen to the bacteria already living in your wastewater, and we add no bacteria and no enzymes of our own. With that oxygen available, the bacteria stop drawing it from sulfate, so hydrogen sulfide is not formed, and the same aerobic bacteria dig into fats, oils, grease and organic sludge that anaerobic conditions leave alone. The compound is consumed as the bacteria use it, so nothing of it stays downstream, and we dose it as far upstream as water and power allow, running it as a monthly service with no capital purchase.

The reason the starting point matters is what happens in the pipe itself. A sewer line, a wet well or a lagoon bottom runs out of dissolved oxygen fast, and once it does, the bacteria already there take their oxygen from sulfate instead, and the sulfide left behind becomes hydrogen sulfide gas, the smell, the corrosion and the gas that kills people in a confined wet well. A manufactured strain riding on a carrier particle still has to reach that same low-oxygen sludge layer and establish itself before it can help; supplying oxygen to the bacteria already there does not.

Four things decide which one fits your system: what each one adds, when it acts relative to the moment hydrogen sulfide forms, what stays in the water once it has worked, and what it costs to run in capital and handling terms.

At a glance

Factor DRP Accelerator Drylet
What is added Usable oxygen for the bacteria already in the wastewater; no bacteria or enzymes added Manufactured bacterial cultures embedded in porous carrier particles, as its website describes them
When it acts Before hydrogen sulfide forms, since those bacteria stop drawing oxygen from sulfate once oxygen is available After the dry product is applied and reaches the sludge layer
What stays downstream Nothing; the compound is consumed as the bacteria use its oxygen, so no chemical additives are left behind The carrier particle and the bacterial population it seeded, as described on its site
Where it reaches As far upstream as water and power allow, into force mains, wet wells and lagoon bottoms Wherever the dry product is applied by hand or by a dealer, with no dosing equipment described
FOG and sludge Digested by the same aerobic bacteria once they have the oxygen A named product for grease traps (Liquify GT) and one for lagoon sludge reduction (BioDredger), separate from its other products
Capital and handling No capital purchase; arrives dry, mixed and activated in a tank on site A dry, hand-applied or dealer-supplied powder, sold as ManureMagic through a dealer network
How it is measured Against a measured baseline, with follow-up readings as part of the monthly service Sonar Mapping Services, a separate sludge measurement and diagnostic offering
Markets it names Municipal, agricultural and oil and gas operators we work with directly Livestock, protein processors, waste-to-energy digester operators, municipal wastewater facilities, and grease traps and kitchen drains

Drylet details come from its site only, checked September 2026, and may change. Confirm with each company.

That table is most of the decision. If it already reads your way, contact us and we will show you the program on your own system.

Where DRP Accelerator is the stronger choice

  • Prevention instead of capture. Hydrogen sulfide is never formed in the first place, because the bacteria already in your wastewater get oxygen before they would otherwise strip it from sulfate. A Drylet biocatalyst, and every added-organism product, works after that gas already exists, once the manufactured strain has had time to reach the sludge layer and take hold.
  • Nothing added that stays behind, and no lab work to keep up with. We add no bacteria, fungi or enzymes, and DRP Accelerator is consumed as the bacteria use its oxygen, so no chemical additives are left in the water once the job is done. Adding bacteria properly also means paying a lab to evaluate what bacteria are already present, an analysis that is costly and has to repeat as a regular part of the program; skip it, as often happens, and an added culture that worked at first dies off or has little effect. There is no carrier particle or seeded population left behind, no strain that has to establish itself, and no lab bill to renew. We only add oxygen: think of it as supercharging your bacteria, and it works continuously, as our bacteria growth test shows.
  • FOG and sludge digested by the same bacteria. The oxygen we supply lets the aerobic bacteria already on site work through fats, oils and grease and organic sludge, instead of reaching for a separate named product, such as Liquify GT for grease traps or BioDredger for lagoon sludge, for each problem in turn.
  • Upstream reach where a dry powder cannot go. We dose as far upstream as water and power allow, into force mains, wet wells and lagoon bottoms that a dry product applied by hand or by a dealer, per barn or per pit, was never built to reach.
  • No capital purchase, a monthly service we run and measure. DRP Accelerator arrives dry, is mixed and activated in a tank on site, and runs as a monthly service built around a measured baseline and follow-up readings, not a dry-powder purchase applied between visits or a separate diagnostic service billed on its own.
  • Works in anaerobic and aerobic water alike, without a strain to establish. The oxygen we deliver reaches bacteria already living in the low-oxygen zones a hand-applied product was never built to solve, with documented before-and-after readings in our case studies.

Where Drylet has the edge

  • A dealer network and a dry product with no dosing equipment. ManureMagic is sold through a network of third-party dealers, as Drylet’s site describes it, with a dealer locator and a separate page inviting distributors to apply, so a livestock operation can buy a dry product locally and apply it itself between pump-outs, with no mixing tank or metered delivery point to set up.
  • A named product built specifically for digester hydrolysis. BioReact is described as boosting hydrolysis in anaerobic digesters, a use case aimed at biogas yield that sits outside the scope of an oxygen-delivery program built around the bacteria already living in a collection system or lagoon.
  • A broad catalog organized by application, plus a separate diagnostic service. Liquify GT, ManureMagic, BioDredger, BioReact and Aqua Assist each target a named use, and Sonar Mapping Services offers sludge measurement and diagnostics as its own line, which suits a buyer who wants one vendor to shop by application rather than by dosing point.

Where DRP Accelerator pulls ahead is the moment the work happens: we prevent hydrogen sulfide before it forms and leave nothing behind, instead of shipping in a manufactured strain that first has to reach the sludge layer and establish itself before it can act.

Already running Drylet? Add DRP Accelerator upstream

Nothing about ManureMagic, BioDredger, Aqua Assist or any other Drylet product has to be removed to add DRP Accelerator. We review your data, work out flow and volume, and survey the site for a dosing point as far upstream as water and power allow, the same way we did at a Texas lift station: a wet well, a headworks channel or the pond itself, upstream of wherever a Drylet product is already applied. We set a measured baseline before changing anything else, then take follow-up readings against it on a schedule that matches your tank size. With usable oxygen reaching the bacteria before hydrogen sulfide can form, an added Drylet product typically has less work left to do, and many sites reduce or retire it once the readings hold, though that decision is always yours to make against your own numbers, not ours. Gas monitors and confined-space procedures at a lift station or wet well stay in place regardless of what the readings show.

How to decide

  1. Find where your own system actually runs out of oxygen, the wet well, the force main or the lagoon bottom, not the barn pit or lagoon a dry product is dosed into by hand.
  2. Ask what each product adds to the water, whether that is a manufactured bacterial strain on a carrier particle or usable oxygen for the population already there, and what, if anything, stays behind once it has done its work.
  3. Ask what happens to fats, oils, grease and sludge at that same point, and whether that takes a separate named product for each problem or the same bacteria already doing the rest of the job once they have the oxygen to do it.
  4. Ask what it costs to run in capital and handling terms, whether it is a dry-powder purchase applied between visits or a monthly service, and how the result gets measured, a separate diagnostic offering or a baseline set before the first dose.

Ask both vendors for the same page

Ask Drylet, and ask us, for the same page: what is added, when it acts relative to the moment hydrogen sulfide forms, what stays downstream, and what it costs to run in capital and handling terms. A fair vendor answers all four questions in the same terms for its own product, not just the ones that favor it. We will show you the program on your own system: where we would set the dosing point, what a measured baseline looks like, and how we report the readings against it once the service is running. Contact us and we will walk through it together, or reach us through our contact page if you would rather start there. We say all of this in public, on this page, because it holds up in public.

A note on this comparison

We wrote this comparison. Every statement about Drylet and its products comes from Drylet’s own website as of September 2026 and may have changed since; confirm current details with Drylet before buying. Waste Water Innovations is not affiliated with, endorsed by or sponsored by Drylet. Drylet, Liquify GT, ManureMagic, BioDredger, BioReact, Aqua Assist and Sonar Mapping Services are trademarks or names belonging to their respective owners.